Call a Mac expert! 888-769-7629
Your Shopping Cart Your Shopping Cart: 0 Items

Your cart is empty.

Ideal Linkmaster UTP/Stp Cable Tester Nic / Mfr. No.: 62-200

Ideal Linkmaster UTP/Stp Cable Tester Nic / Mfr. No.: 62-200
Qty. Available: 10+
Item Number: ide-62200
Vendor Number: 62-200
Vendor: Ideal Ind-Custom Install
Chat with or call a Mac expert at 1-888-769-76291-888-769-7629
Shipping: Usually ships within 24 hours.

The LinkMaster PRO Tester enables installers,contractors and maintenance technicians to map, test and troubleshoot data and voice communication cable and coax runs. Rugged, versatile, and easy-to-use, the LinkMaster PRO tester has mastered the link between performance, simplicity and value for both commercial and residential applications.

General Information

ManufacturerIDEAL Industries, Inc
Manufacturer Part Number62-200
Manufacturer Website Address
Product LineLinkMaster PRO
Product NameLinkMaster PRO Tester
Product TypeNetwork Testing Device

Technical Information

Device FunctionSplit Pair Testing
Minimum Length Measurement3 ft
Maximum Length Measurement600 ft


Network (RJ-45)Yes
Number of Network (RJ-45) Ports2


Status Indicators
  • Battery low LED
  • OPEN - There is no "OPEN" LED indication. A typical cable may have 2, 3, or 4 pairs. OPENS are displayed as an unlit LED. The user will determine if a pair is present and continuous or OPEN by comparing the illuminated LEDs to the expected number of pairs that should be good. For example, when testing a 4 pair cable, three illuminated LEDs in the PASS area indicate the presence of an OPEN condition in one of the pairs
  • SHORT - A short circuit condition exists
  • MISWIRE - Indicates the improper assignment of individual wire pairs to pins for the wiring schemes tested. Tester checks T568A, T568B, 10Base-T, and Token Ring configurations
  • REVERSAL - Reverse wiring means the pin for one wire in a pair is connected to the opposite pin for the pair in the remote jack
  • SPLITPAIRS - Split Pairs occur when the tip (positive conductor) and ring (negative conductor) of two twisted pairs are interchanged

Pass Indicators:

  • T568A and T568B
  • Four green LEDs on pairs 1-2, 3-6, 4-5, and 7-8. All four pairs are terminated correctly
  • Token Ring
  • Two green LEDs on pairs 3-6, and 4-5. Both pairs terminated correctly
  • 10 Base-T
  • Two green LEDs on pairs 1-2, and 3-6. Both pairs terminated correctly
  • Shield
  • Green SHIELD LED indicates the shield on the cable is correctly and continuously wired through the modular plug termination

FAIL Indicators:

  • A flashing pair LED indicates that this wire pair has a fault. A flashing LED in the FAIL section will indicate which fault was detected. Multiple flashing LEDs indicate multiple pairs and/or multiple faults. Best practice is to correct cable faults until cable is verified as correct with appropriate green LEDs

Battery Information

Battery Size SupportedAA

Physical Characteristics

Weight (Approximate)2 lb